How to activate the TK303 GPS Tracker

The Tracking device TK303 GPS Tracker from Shepherd Chinese is one of the most popular tracking devices around the world. In this article, you will learn how to activate the device step by step.

Turn on TK303 GPS for the first time

1. Open the back cover of the device using the appropriate tool
2. Insert the slide into the appropriate place according to the specified direction
3. Turn on the device from the power button next to the chip
4. If the lights do not light, this means that the internal battery is not charged. To turn on the device and charge the internal battery, connect the positive and negative wires (red and black) to the car’s 12 volt or 24 volt power system. Wait for a minute after connecting the power, then turn on the battery switch. the reserve

To activate tracking devices and obtain a unique tracking program, contact us on WhatsApp +966570960313

Configure the device for use and password

To configure the device and activate the default password, send a text message containing the code begin123456 To the SIM number inside the device, the device will respond with the phrase: Begin OK Then it configures all settings to the default settings (the default password is 123456 and must be used when sending any code to the device)

Set the admin number for the TK303 GPS device

To set the number send admin123456 00123456789 Make sure of the full number, including the international code, adding 00 at the beginning (the admin number is the number to which the device will respond to send a location command, listen to sounds, or stop the vehicle)

Locate the vehicle

1. To locate by calling: Call the SIM number inside it from the admin number and the device will hang up and send a text message with the link to the location on Google Maps, speed, coordinates and time.
2. To determine location via text messages: Send a text message containing the code position123456 From the admin number, the device will respond with the location details as shown in the picture

Remotely stop the vehicle

1. To stop the engine remotely send the code stop123456 When the command is executed, the device will respond Stop Engine Succeed In the default case, the vehicle stop command is executed only when the speed is less than 20 km/h
2. If you want to stop the engine immediately and execute the command without waiting for the vehicle’s speed to decrease, send quickstop123456 The device will respond Quickstop OK
3. To restart the engine send resume123456 To confirm that the command has been activated, the device responds Resume Engine Succeed

Read also:

• The best tracking software for various types of devices
• How to activate the TK311 tracking device
• Commands and scripts for the FMB120 tracker
• List of Codes and SMS Commnds for GT06N
• How to activate the tracking device

Live tracking via the app

To track the device through the application, the server and access point settings must be configured (To get a special application, contact us)

• To set the server send: adminip123456 57.154.545.1 (replace 57.154.545.1 With your server address) to confirm, the device will respond Adminip OK
• To set the access point, send:APN123456 internet (replace Internet In the name of your access point) to confirm the device will respond APN OK

Important commands and codes for the TK303 GPS device

• Reboot the device: Reset123456. Device response: Reset OK
• change password: password123456 888888 (replace 888888 With the new password and it must be 6 numbers) Reply: Password OK
• Receive a message when the device is disconnected: extpower123456 on When this code is activated, the backup battery works and the device sends an alert with the vehicle’s location coordinates every 3 minutes to the admin number. To cancel the alert send extpower123456 off
• Over speed alert: speed123456 080 In this example, the device sends an alert when the vehicle exceeds a speed of 80 km/h. Reply: Speed ​​OK