How to activate the GT06 GPS tracking device
Table of contents (click to go to section)
How to activate the GT06 GPS device to track vehicles, step by step with pictures and a list of codes and text commands
To activate tracking devices and obtain a unique tracking program, contact us on WhatsApp +966570960313
The first step: Insert the SIM and turn on the GT06 GPS device
- Enter the card according to the picture shown below, and the SIM card must have an internet balance for tracking through the application and a text message balance for sending activation codes and tracking via text messages OFFLINE.
- Turn on the device from the button according to the picture (some models do not have a power button and the device must be connected to a 12V power source)
Status and meaning of lights
- Red = Battery: If it is in rest mode, this means that the internal battery is charged and working normally
- Green/Yellow = Mobile network: If it is in stable mode, it means that the SIM card is working well and is connected to the Internet
- Blue = Satellite connection: If it is in stable mode, this means that the device is connected to satellites and has determined the location
Note: All lights turn off after 5 minutes. If you chip the device or the device receives any command via SMS, it will turn on the lights for 5 minutes.
How to connect the GT06 wires to the vehicle
- Red wire: Connect to direct power supply (+)
- Black wire: Connect to the negative power supply (ground -)
- Yellow wire: Connect to the Relay (yellow wire)
- Green wire: Connecting to the ACC switch wire, which works when the vehicle is running
- SOS emergency button input: Connect to the emergency button included with the device, which sends an alert when pressed for 4 seconds
Read also:
- The best tracking software for various types of devices
- How to activate the PG12 tracking device
- Commands and scripts for the FMB120 tracker
- List of Codes and SMS Commnds for GT06N
Where to install the GT06 GPS device inside the car
Shown in the picture are some suggested places for installing the tracking device inside the car. Make sure to point the antenna towards the sky to obtain the satellite signal and determine the location accurately.
GT06 GPS commands and scripts
Below are the text codes for programming the GT06 device, taking into account that the default password for the device is 123456 and the password must be added when sending any code to the device
- Setting the server and tracking software: #IP#password#ip address#port# (To obtain a unique tracking program, contact us)
- Set access point: #APN#123456#INTERNET#
- Get the device's location via Google Maps link: #smslink#password#
- Details of device settings and status: TCP
- Stop the vehicle remotely: #stopoil#password#
- Remote confusing restart: #supplyoil#password#
- change password: #password#old password#new password#
- Set engine start alert: #ACC#ON#
- Set engine shutdown alert: #ACC#OFF#
- Set over speed alert: #speed#password#speed number#
- Turn off speeding alert: #nospeed#password#
- Set admin number: #admin#password#phone number#
- Delete admin number: #noadmin#password#phone number#
- Reboot the device:#begin#password#
- Listening to the device's surroundings: #monitor#password#